GrndAdmThrawn wrote:
>
> I'm wondering how you would like take two cylinder at like 90 degree or 45
> degree then put the end together but the end part would stick out of each
> others, how would u cut those end part off and delete it so the pipe like
> fits together without any gap or junk sticking out??
>
> kind of like
>
> /|\
> / / \ \
> / / \ \
>
> thanks in advance
You could use an intersection between an infinite cylinder from
shapes.inc and a plane. I usually just stick in a sphere to close the
gap.
--
Dan Johnson
http://www.geocities.com/zapob
Post a reply to this message
|